Technical parameters and characteristics of high-speed guardrail moulding machine

Technical parameters:

1. Loading.

1. Single-end uncoiler, single-side f

2. Automatic hydraulic internal tension

3. Maximum winding weight: 8000KG

4. Maximum winding diameter: 2200mm

5. Hydraulic power: 3KW

6. Cylinder diameter: 120mm, working pressure 10Mpa

7. Maximum winding width 500 mm

Two. Molding

2017nian3yue 24 033

 

1. Feeding into the guide wheel of the unit

2. Leveling up to three rolls and down to four rolls, forming shaft diameter 80mm (material 45# through conditioning), roll material GCR15, quenching to HRC58 -62, hard chromium plating on the surface, pressing thickness 2.5m-3.0m.

3. Punching: Hydraulic Punching (material Cr12 die steel quenching treatment, can be left and right arbitrary adjustment)

4. Cut off hydraulic shear (Cr12 quenched HRC60-62)

5. Host power: 15KW

6. Cycloid pin reducer power: 15KW

7. Drive: Chain Drive, 2-inch Single-row Chain

8. Motor Power of Hydraulic Station: 15KW, Pressure 20Mpa

9. Frequency Conversion Speed Regulation 5-12 m/min for Unit

10. Inverter, Delta
1. The computer uses Delta PLC

12. Touch screen display for computer operation panel

13. Outward Size of Equipment: 17.5m in length, 1.2m in width and 1.5m in height

14. Electrical appliances origin and brand are optional.

Three. Discharging

Simple discharging rack

1. The frame is welded by 60mm *40mm square pipe (adjustable up and down)

2. Install sliding wheels on the rack

3. Specification: 1.5 m long, 0.9 m wide and 0.6 m high

gshl

Leave a Reply

Your email address will not be published.